Brake caliper cleaning and lubrication
Cold-weather corrosion-prevention service for salted roads.
Verified2024 Tesla Model Y / Long Range AWD
Owner maintenance and common replacements
Factory intervals, fitment limits, tools, fluids, torque information, and common home-service searches.
← Back to specificationsConfiguration-specific service and fitment facts
These sourced values are shared by the specification sheet and the maintenance guides for this exact configuration.
- Cabin filters required
- 2 Verified
- Cabin filter cover screw torque, if fitted
- 1 lb-ft Verified
- HEPA cover screw torque
- 1 lb-ft Verified
- HEPA assembly bolt torque
- 4 lb-ft VerifiedTwo assembly mounting bolts, 10 mm socket. The service manual allows reuse in its table but explicitly requires new bolts for rework; retain that exception. Follow the installed washer-neck fastener variant and the model-specific service procedure.
- Wheel package
- 19 × 9.5J ET45 standard; 20 × 9.5J ET45 available Verified
- Front tire
- 255/45R19 XL standard Verified
- Wheel lug torque
- 129 lb-ft Verified
- Front wiper set application
- 3397014621 Verified
- Driver wiper length
- 25.6 in Verified
- Passenger wiper length
- 19.7 in Verified
- Cabin filter application
- DVF5079 Verified
Brake fluid health
Check fluid health rather than replacing solely by elapsed time; heavy brake use can shorten the interval.
VerifiedBrake pads and rotors
Inspect for wear, rust, and free movement; regenerative braking can reduce use of the friction brakes.
VerifiedBulbs and fuses
Match the installed bulb or fuse rating exactly and diagnose repeat failures before replacing again.
VerifiedCabin air filter
Switch off climate control before accessing the right front footwell. Disconnect the cover connectors by their housings, never the wires. Replace both filters, lower first, with arrows pointing rearward. Refit the cover; the screw-equipped version uses 1.2 Nm. Tab-equipped covers do not use that screw torque.
VerifiedHEPA and carbon filters
For equipped vehicles, replace the HEPA and carbon elements as a matched set. Fully seat the seals and follow the specified filter orientation. Use the model-specific service procedure and the sourced fastener values below; retain any required replacement hardware and installed-equipment exceptions.
VerifiedLow-voltage battery
Inspect the case, terminals, hold-down, and starting behavior before choosing the exact replacement type.
VerifiedTire rotation and wear
Rotation timing, staggered-wheel limitations, pressure, and wear trigger.
VerifiedWiper blades
Park, switch off the wipers and enable Wiper Service Mode. Lift each arm only enough to release its blade, with a towel protecting the glass. Fit the matching connector, then confirm the new blade locks with a push-pull check before leaving service mode. Arms do not lock upright.
Verified